Parts & Accessories
Purchase Enersol Parts
Below is a list of Enersol Pool Heater parts and accessories that can be purchased directly through www.solarthermal.com. If you live in a country that is not listed on the website, please Contact Us and we can assist you further.
For instructions on how to do a repair, visit our Downloads page for videos and documents.
Enersol Pool Heater
UPC-ESOL-108 – UPC-ESOL-110 – UPC-ESOL-112 – Enersol solar pool panels. The Enersol solar pool heating panel will become the main component of your solar pool heating system. Hardware kit is included.
Installation System Kit
UPP-ESOL-SYSKT – Enersol System Kit – one per installation Contains: installation guide, warranty card, installation tool, 2 O rings, 1 O ring lubricant, 2 HEC (header end connectors), 1 roof sealant, 2 end caps, 1 Teflon tape, 1 top strap (12 inch), and 1 lag bolt.
Hayward Controller
ASC-GLC-1PA – The The AquaSolar GL-235 Solar Control System used divert the water to the solar panels when there is sufficient solar energy to capture and turn it off when there are no more solar gains available or needed
Perma-Seal Manual 3-Way Valve
XAA436 – Manual 3 way valve (1 1/2″ or 2″) compatible with pool water and can be used manually or with an actuator (sold separately)
Panel Repair Kit
UPP-ESOL-REPKT – Enersol Panel Repair Kit contains: 2 headers, 2 clips, 2 O-rings, 1 install tool, 2 instruction sheets, 12 splicers, 1 piece of rubber
Enersol Rubber Strips – 98ft roll
ESOL-RBR98 – Enersol Solarprene rubber strip sold by the roll (98ft) used to replace the strips on Enersol panels
Enersol Header
UPP-ESOL-HWN4P – Enersol Header black ASA weather resistant polymer 13 1/2″ long (4 Pack)
Enersol Header End Connector
UPP-ESOL-HEC4P -Enersol Header End Connector (HEC) (4 Pack). Clips into system as a spacer, or can be used as a connector at the inlet and outlet of the system
Enersol Header Clip
UPP-ESOL-5CLIP – Enersol Header Clip black premium polycarbonate 2.25″X2.5″ custom designed to lock headers together (5 Pack)
Enersol Installation Tool Kit
UPP-ESOL-INSTL – Enersol installation tool and o-ring lubricant. Used to assemble headers together, or to pull them apart. This tool MUST be used to protect the o-ring.
End Caps (Adapter and Plug)
End Cap (XAA401 &XAA402) – The End Cap is made up of two parts: adapter and plug. Installed at the opposite corner of the solar panel system and low spots to allow for proper drainage
Enersol Cross Strap Kit – Panel
UPP-ESOL-STR48 – Enersol Panel Strap Kit contains 2 lag bolts and 1 panel strap (51 inches long) to strap 1 panel across
Enersol Top Strap Kit – Header
UPP-ESOL-STR12 -Enersol Header Strap Kit contains 2 lag bolts and 2 header straps (12 inches long) used to mount 1 panel
Enersol Hardware Kit
UPP-ESOL-HWKT1 – Hardware Kit contains: 1 header strap, 1 panel strap, 2 O-rings, 2 clips, 3 lag bolts. This is included in each panel box.
Water Sensor 10k for Controller
UPP-ESOL-WSENS – Water Sensor 10K Used with the Automatic Controller, installed on feed line. Compatible with both the Pentair and Hayward automatic system controllers.
Roof Sensor 10k for Controller
UPP-ESOL-RSENS – Roof Sensor 10K Used with the Automatic controller, installed on the roof to measure the temperature. Compatible with both the Pentair and Hayward automatic system controllers.
Enersol Rubber Splicing Kit
UPP-ESOL-SPLCE – Enersol Rubber Repair Kit used to repair minor rubber punctures. This repair kit contains:4 inches of rubber and12 splicers.